Assembly

Assemble Step

The video of the assembly step. Coming soon.

  1. Fix 4 M3 Screw Nut and 11 M2.5 Screw Nut on the reserved slot of the Fixed Frame.

  1. Fix the OLED with 4 M3*6 Screw and 4 M3 Screw Nuts.

  1. Fix the DJI TB48S Battery Shelf with 12 M3*6 Screw.

  1. Connect the interface of the OLED with the 20cm XH2.54<->XH2.54 4P.

  1. Fix the MTi 630 with 3 M2*7 Screw.

  1. Fix the Power and Communication Board with 2 M3*12 Screw.

  1. Fix the Remote Control and OLED Board with 2 M3*18 Screw and 2 φ3 h6 Shims.

  1. Connect the OLED. Connect the Power and Communication Board and the Remote Control and OLED Board with the 6cm ZH1.5<->ZH1.5 4P.

  1. Fix the Jetson Orin NX with 4 M2.5*10 Screw.

  1. Fix the Power Extend Board with 4 M2.5*10 Screw.

  1. Fix the GMKtec NUCBOX K11 with 4 M3*6 Screw.

  1. Fix the SMA interface into the preserved hole and screw the 2.4G/5.8G 2DBI 4cm Antenna.

  1. Connect the power interface of the GMKtec NUCBOX K11 \ Jetson Orin NX and the 19V_OUT of the Power and Communication Board with the 7cm XT30<->XT30 \ 17cm XT30<->XT30.

  1. Connect the MOTOR_1-4 \ MOTOR_9-12 of the Power and Communication Board and the Power Extend Board with 28cm XT30(2+2)<->XT30(2+2) \ 16cm XT30(2+2)<->XT30(2+2).

  1. Fix the wire with the plastic strip.

  1. Connect the USB0 \ USB1 of the GMKtec NUCBOX K11 and the USB COM of the Power and Communication Board \ the MTi 630 with the 15cm Type-C<->USB-A.

  1. Fix the Shell with 8 M3*12 Screw and 20 M3*8 Screw.

  1. Put the DJI TB48S Battery on the DJI TB48S Battery Shelf.

PreviousFirmwareNextSetup

Last updated